In other words, you would pull the reamer through the holes rather than
pushing. I would certainly not try to add the required cutting edge by
hand, but a tool-maker could do it fairly easily, if you know one that is
willing to do some "government" work...
Mike
> The reamer will still be turned in the same direction. The difference is
> that you will want it to cut from the shank end of the flutes instead of
> from the normal end. To do this, the back end of the flutes must have a
> shape with a cutting angle put on them. The shank will pass through both
> bushing holes to keep them aligned.
>
> Greg Gelhar
>
|