[TR] Removing Front Grease Caps/GT6?

[ahwahneetr at gmail.com (Geo Hahn)]

On 2/27/11, Gary Klein <tr6.guy at verizon.net> wrote:
> Here's a better technique that won't mark up the cap.  It works on my TR6
> and TR8 so I suspect it will work on the GT6.  Screw in a #10 bolt into the
> hole of the cap, about a 1" or so long bolt will do with a fine thread.  It
> will seat on the stub axle end and slowly extract the cap.

And if you use an eye bolt (about 2" long) you can do this w/o a
wrench, just turn the screw eye by hand (unless the cap it rusted or
otherwise stuck).

Geo