Thanks Randall. Yes, I can see the noted channel on mine but was not aware
that a packing would go there, but this would certainly help seal the
spacing so noted. I would assume some form of silicon gasket would be best,
such as The Right Stuff, so as to remain flexible and to seal out water. I
am still concerned with the variance in measurements with the windscreen and
the stanchions.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of Randall
Sent: Sunday, January 17, 2010 12:20 PM
To: 'Triumph Mail List'
Subject: Re: [TR] TR3A Windscreen Installation
> With the guide plates
> installed and the
> stanchions installed, with the dzus fasteners, there is still
> a bit of a gap
> between the body and the stanchions.
Scott, I've never tried installing just the stanchions without the
windscreen; but I believe there should be a small gap between the stanchions
and the body. Otherwise, they will rub the paint off as the body flexes
(and it does flex).
There is a channel inside the curve of the stanchions, that is supposed to
receive some sort of packing for water sealing. Here's a shot of the area
on my (very dirty at the time) TR3:
http://tinyurl.com/yzofdcr
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $11.47
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|