Gang,
would hope this information is shared with the remainder of the list!!
Regards,
Dan Cronin
--- On Tue, 1/12/10, J.C. Hassall <jhassall@blacksburg.net> wrote:
From: J.C. Hassall <jhassall@blacksburg.net>
Subject: Re: [TR] TR-3/4 main cap bolts / ARP
To: "Tony Drews" <tony@tonydrews.com>
Cc: Triumphs@autox.team.net, jhassall@vt.edu
Date: Tuesday, January 12, 2010, 11:09 PM
On 1/12/2010 10:52 PM, Tony Drews wrote:
> Anyone have info on dimensions for TR-4 main cap bolts? The manual shows
1/2" UNC but not the length. I'm trying to figure out what ARP bolts you
would buy to replace the stock bolts, and also one that's 1/2" longer to allow
for "strapping" the center main. If I had the dimensions (length) I could try
to cross reference the engines that ARP lists main cap bolts for.
Tony, 3.5 inches under the head. I can give you the ARP number tomorrow, but
don't have access to my build log right now.
jim
>
> Thanks in advance,
> Tony Drews
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $11.47
>
>
> You are subscribed as jhassall@blacksburg.net
>
> Triumphs@autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> http://www.team.net/archive
>
>
-- Jim Hassall
Blacksburg VA
'63 TR4 in autox preparation
99% finished, 90% to go
Suggested annual donation $11.47
You are subscribed as adcronin@ameritech.net
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $11.47
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|