triumphs
[Top] [All Lists]

Re: [TR] TR4 Slave Cylinder Stay Rod

To: "'Glenn Owen'" <mgowen55@hotmail.com>, "'Triumph Mailing List'"
Subject: Re: [TR] TR4 Slave Cylinder Stay Rod
From: Tony Drews <tony@tonydrews.com>
Date: Wed, 17 Jun 2009 21:47:55 -0500
Good point.  I have a late TR-4 or TR-6 tranny with the thicker flange.

- Tony

At 12:01 PM 6/17/2009, Jim Bauder wrote:
>I had the misfortune to operate a TR3 Transmission without that stay rod for
>some amount of time and finally the bell housing cracked for about 
>12 inches all
>the way around the curve of the bell housing and ruining the transmission!
>
>I believe that the use of this stay rod brace was eliminated on later
>transmissions. If you measure the thickness of the bell housing flange that
>bolts to the engine, it is about 3/8 of an inch thick on the early 
>transmissions
>but close to 1/2 inch or more on the later transmissions! Much 
>stronger! I don't
>know when this change occurred, but my guess is it changed when the gear box
>went to a synchro 1st gear.
>
>My TR250 does not have a stay rod however, I can't speak with any authority
>about the TR4. But if you measure the thickness of that flange and it is ~1/2
>inch you are pretty safe!
>
>HTH and good luck,
>
>Jim
>Jim Bauder
>480-309-9525
>'68 TR250 CD47L
>Scottsdale, AZ
>http://www.triumphowners.com/647
>
>-----Original Message-----
>From: triumphs-bounces@autox.team.net [mailto:triumphs-bounces@autox.team.net]
>On Behalf Of Glenn Owen
>Sent: Tuesday, June 16, 2009 2:11 PM
>To: Triumph Mailing List
>Subject: [TR] TR4 Slave Cylinder Stay Rod
>
>My 67 TR4A is not fitted with the stay rod that runs from the oil pan bolt to
>the clutch slave cylinder mounting hole. I assume it was discarded long ago by
>some mechanic as a matter of convenience. Is it safe to operate the 
>car without
>the rod or am I risking some sort of catastrophic failure if I don't 
>replace it?
>Thanks
>
>Glenn
>67 TR4A CTC76828LO
>Triumphs@autox.team.net
>http://autox.team.net/mailman/listinfo/triumphs
>
>You are subscribed as jimbpps@cox.net
>
>http://www.team.net/archive
>_______________________________________________
>
>Support Team.Net  http://www.team.net/donate.html
>
>This list supported in part by the Vintage Triumph Register
>http://www.vtr.org
>
>
>Triumphs@autox.team.net
>http://autox.team.net/mailman/listinfo/triumphs
>
>You are subscribed as tony@tonydrews.com
>
>http://www.team.net/archive
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>