Terry,
You could mark the hole locations with the plates, drill a hole and
pop-rivet the caged nuts into place on the back side of the lip. Had to do
one on mine like this, I'll never tell where.
Bill B
'58 TR-3A TS/30766 L
'59 TR-3A TS/64974 LO
"A Triumph is man's best friend, it always comes when it is called...of
course, some times it is difficult to make it go"
-----Original Message-----
From: triumphs-bounces@autox.team.net
[mailto:triumphs-bounces@autox.team.net] On Behalf Of DLylis@aol.com
Sent: Saturday, March 14, 2009 5:03 PM
To: terryrs@comcast.net; triumphs@autox.team.net
Subject: Re: [TR] Bulkhead Sealer Plate Fasteners
There are such things as rivet nuts that will leave you with a threaded
hole. Probably preferable to any general hardware store solution. Try
this
_http://www.mcmaster.com/#rivet-nuts/=105ddx_
(http://www.mcmaster.com/#rivet-nuts/=105ddx)
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
**************Worried about job security? Check out the 5 safest jobs in a
recession.
(http://jobs.aol.com/gallery/growing-job-industries?ncid=emlcntuscare0000000
2)
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as wbeech@flash.net
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|