Hello,
I just finished tightening the 2 bolts/nuts that hold the right rear shock.
I would like to use a socket wrench but my sockets all are too big to fit that
small area.
Does anyone know where I might get a 9/16 inch thin wall socket for this
application?
I used a box wrench on the bolt but had to use an open end wrench at an angle
on the nut. Really cant torque it down like I want too.
My sockets are Craftman 1/2 and 3/8 " drive.
Thanks for the help.
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|