> Yes, I have the correct cable (96").
Chuck, I'm going to go out on a limb and say I disagree with you. According
to memory and the info I have handy, the OD 4A used a shorter cable combined
with an angle drive.
The earlier models used the 96" cable, with no angle drive. The lack of
angle drive forced the cable to make a big, wide loop under the RH floorpan
to match the drive on the OD without crimping the cable, hence the long
length. But the redesigned tunnel for the 4A no longer allowed that
approach, hence the introduction of the angle drive.
Randall
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|