In a message dated 8/29/2007 10:51:08 A.M. Eastern Standard Time,
tr3driver@ca.rr.com writes:
How much endplay is there on the cam & crank ? Are you checking alignment
with them both pushed all the way back ? Is the front cam bearing new ? Are
you sure the crank chainwheel is seated firmly against it's shoulder ?
Crank end float .006" which is at the upper limit of acceptable but still
acceptable. Checked with a dial indicator
Cam endfloat is .005" should be .003 - .0075" Checked with a dial
indicator
Front cam bearing is used but not used by me as my old one was scored. It
is in very good shape.
I will seat everybody firmly and check again but I pushed them both back as
much as I could.
Thanks, as always
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|