My crank chainwheel stands .0045" proud of the cam chainwheel when aligned
with a straightedge. (new parts) This does not include the use of any crank
shims. Is it OK to lap the rear surface of the chainwheel or is this w/in
tolerance?
The cam chainwheel runs out .002 - .003" but the original ran out .015" so I
am guessing that I am OK.
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|