triumphs
[Top] [All Lists]

Re: Steering Rack

To: "List" <triumphs@Autox.Team.Net>
Subject: Re: Steering Rack
Date: Sat, 25 Dec 2004 00:18:37 -0000
References: <OF6FB8B0CA.57384902-ONCC256F74.006A0FE9-CC256F74.006AE993@robertson.org.nz>
Hi David
I have a way to do this, I drop a socket that will just fit in the hole down
on to the bush then send a 12 inch extension in after it, then just shake
the lot up and down until the weight of the extension taps the bush out, it
usually takes one heavy shake to start it moving and then maybe a dozen more
smaller shakes to drive it right out.

Graham.

----- Original Message ----- 
From "David Robertson"
Sent: Friday, December 24, 2004 7:27 PM
Subject: Re: Steering Rack



>
> I haven't replaced this bush on a TR6 but I've done a few 2000/2500 sedans
> & I'd surprised if there'e much difference. The only difficult part is
> getting the old bush out. I use a piece of a hacksaw blade to cut most of
> the way through the bush & then a very small chisel between the bush & the
> housing to collapse the bush. Replacement just taps in. The rest of the
> rack rebuild is really just cleaning & adjusting, assuming you don't have
> significant wear in the gear teeth (and I think your checking would have
> shown it if you did).
>
> Regards,
> David Robertson



---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.813 / Virus Database: 553 - Release Date: 14/12/2004




<Prev in Thread] Current Thread [Next in Thread>