Folks,
I replied to Randall separately but since this thread is still alive (nice
drawing Mark!) thought I should let you know that the dimensions had to be
changed from what's shown, in order to accommodate the TR range.
Those shown in the drawing will not fit the TR3, but will work for the 6.
Not sure about 4/4A/5/250.
So, if you are going to make one for a TR3 let me know and I'll tell you
the changes.
Jim Wallace
2TS81417L
+++++++++++++++++++++++
From: "Musson, Carl"
Mark - either 1) you have a new toy or 2) you have too much time on your
hands. But it sure looks like it is straight out of a catalog.
Also, aren't computers fun? :^)
-----Original Message-----
From: Mark Gendron
I couldn't resist producing a CAD rendition, complete with moody lighting:
http://www.canleyworks.com/graphics/hub_puller.jpg
- -----Original Message-----
From: Randall Young
Ok, I found it. Thanks go to Tony Gordon for masterminding the plot, and
to Dan Buettner for posting the information. The hub puller drawing (and
lots of other good info) can be found at
http://www.thelittlemacshop.com/trsite/download.html
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|
