If any of you might be able to advise Dave, please make sure to include him
in your reply at the address below. Thanks!
--Andy Mace
> --- dave worne <daveworne@hotmail.com> wrote:
> > From: "dave worne" <daveworne@hotmail.com>
> > To: vtr-www@www.vtr.org
> > Subject: High Tensile Bolts
> > Date: Tue, 04 Jun 2002 18:47:00 +0000
> >
> >
> > Hi folks, I'm a member of the TR Register in the UK,
> > I drive a 4A and I have
> > a 6 currently undergoing a ground up restoration.
> > My problem is that I took this on as an abandoned
> > project and the two halves
> > of the Girling Calipers had been unbolted.
> > I am having a difficulty finding the proper bolts in
> > the UK - I can find the
> > correct sizes etc but not the correct tensile
> > strength.
> > Details as follows:- (for a vehicle set)
> >
> > 4 - 7/16"UNF x 21/4" long.
> > 4 - 3/8 UNF 21/8" long. (21/4" acceptable)
> > The bolts require to be Type 'U' - 60 tons tensile,
> > which is where my
> > difficulty lies. I can obtain the sizes, but not the
> > tensile strength.
> >
> > I wonder if I may ask your goodselves to e-mail me
> > the details of a few bolt
> > stockists/suppliers in the USA who I may contact in
> > persuance of the above.
> >
> > Thanking you for any help you may be able to offer.
> >
> > Regards
> > Dave Worne (phones ++ 44 1246 473979/++ 7970
> > 754030)
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|