Eric,
The best bet would be to go over it now with a couple of coats of POR-15.
This should help stop the progression of the rust inthe 'pits'.
Mark
'80 Spit
At 10:14 AM 1/8/99 -0800, Eric wrote:
>
>Helo List,
>I recently removed the carpet from my newely purchased TR6 only to discover
>surface rust. There are no holes in the floors yet. I started to sand the
>floors with 60 grit on an orbital sander. That took off some of the rust
>but the floor has thousands of rusty pits below the sanding surface. My
>question is how much of the rust do I need to remove? I am afraid to sand
>down to much as I will sand right through the floors.
>TIA,
>Eric
>74 TR6
>
>
|