Re: engine rebuild

[John Middlesworth <jape@email.unc.edu>]

To hold the 4-cylinder wet liners in place during a rebuild, I find it
easiest to buy four or five large bolts, an inch long, along with a few
large flat washers.  Screw these bolts with their washers into the holes
for the studs.  You won't need a bolt for every hole, just enough to hold
each liner down on two opposing sides.

A lot easier to handle and place upside down than having studs sticking up 
five or six inches!

John Middlesworth 
1966 TR4A
1960 TR3A