Gano, Ken wrote:
>
> Upon assembly of crankshaft in block with bearing caps installed, crank is
> very hard to turn over. Any suggestions besides checking journal diameter
> with mike?
>
> kengano@advant.com
> downstate illinois
> 1959 TR3A TS57756L
> 1958 Model 10 Sedan TBE9239LDLB
torque=TORQUE=torque, are all bearings installed correctly, is the slot
in proper location, was the crank turned during rebuild,are they the
correct size bearings, did you mark each bearing during dismantling. This
is a lot to think of but she should not be hard to turn as a matter of
fact you should be able to turn by hand.
|