JAMES_S_WALLACE@HP-Canada-om1.om.hp.com wrote:
>
> Steve,
> If you have welding equipment, weld a new big nut on to the head of
> the bolt. If you don't have welding equipment, you're like me. Usually
> I end up tightening vice-grips so that it's all I can do to close
> them. Then the head of the bolt breaks off. Kind of an anti-climax,
> but it works.
Take the Gibbonizer (Dremel Tool) and cut two flat spots on opposite
sides. Then use a vice grips or any really good brutal wrench.
--
Trevor Boicey
Ottawa, Canada
tboicey@brit.ca
http://www.brit.ca/~tboicey/
|