Mike,
At 19:24 23/02/98 -0600, you wrote:
>Following the lines of thought to repair the block, I visited a local machine
>shop and the guy said he could find the "right" folks to weld up the block
and >crank, then machine them down again.
It's not a vintage Ferrari, so there should be no need to go to extremes to
repair a block. You should be able to get a good one for $100-$200, I would
think. And the repair described would cost at least that.
You might even sell the old one as a boat anchor!
Allen Nugent
Graduate School of Biomedical Engineering
University of New South Wales
Sydney 2052 Australia
|