I'm about ready to remove the interior of my TR4 and a lot of the material
is original and would look fine when I clean it and use some armourall on
it. My question is what is a good way to remove the vinyl from wheel arches
and other areas where it may be "glued"? I'd hate to loose the original
material if there is a way to prevent it.
Has anyone tried this and been successful? And if you tried it and were
unsuccessful, let me know also, so I don't fall in the same pit!
Thanks.
Doug Mathews
Weekdays Voice: 706-542-6820 FAX: 706-542-6881
64TR4 TC38798L(in restoration)
63TR3B TCF1520L(Driver)
59TR3A TS6140L(Parts creature)
57TR3 TS18791LO(Parts creature)
|