>
>
>
>I have seen some traffic here about refinishing wood veneer dashes, but does
>anyone have any good advise regarding replacing the veneer? A local furniture
>refinishing shop has told me to glue the veneer with contact cement. However,
>I wonder if that would stand the heat of several hours of the hot Texas sun.
>Should I use wood glue instead?
>
>Any good advise out there?
>
>Thanks
>
>Jim Snyder
>'71 TR6 (in pieces)
>
>
Jim,
I redid the dashes of my 68 GT6 and 64 TR4. I used Scotch 3M contact
cement in the aerosol ca. There are 3 varieties, 60, 70 and 90.
90 Is the only one that will stand up to the heat. Can also be used on
headliners. The others let go.
I did the GT6 3 years ago and it's still flat, no bubbles or lifting.
I know about the sun, I'm in El Paso.
Best Regards,
Tony R.
"GT6s"
###
|