White grease for things that slide, penetrating MC chain lube for the pivot
points and the clutch assembly where the handle cranks the regulator. STP
also works well in lots of areas.
In a message dated 10/21/2013 4:57:35 P.M. Pacific Daylight Time,
drmayf@mayfco.com writes:
I think a few days ago I think I saw a response that said lube the pin
type joints with a heavy gear lube such as a 90 - 140 weight oil. Did I
see that right or was my blind eye looking else where.. What was the
recommendation for those small rotating joints? Next is what grease
would be used for the gear winder and teeth. Looks to be a more solid
grease than axle grease, but what is a good substitute? And then the
track under the window that pushes it up and down..has same grease as
the gears I think,,, but what is it or a good substitute?
Finally putting the drivers door back together... then the soft top,
then the soft top cover then the dash pad, then,. then then
mayf
--
______________________________
drmayf
Worlds Fastest Sunbeam, period.
204.913 mph flying mile
210.779 mph exit speed
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/tigers/aaaglasss@aol.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|