Russ
The 260 clutch arm is part # C3AZ-7515-A.
I believe that arm was upgraded in 65 for the 6 bolt 289 but not curtain of
that. This part is available at Mustangs Unlimited, California mustang and
the like. The catalogs also indicate another change at 2/15/68.
You might want to call one of them to confirm the length of the arm unless
someone on the list can measure one for you.
There is also the possibility that the clutch arm from the 6 cyl was used
for the 289 but I do not have enough information on hand to say for sure.
Hope this helps you some.
Ron Fraser
-----Original Message-----
From: tigers-bounces+rfraser=bluefrog.com@autox.team.net
[mailto:tigers-bounces+rfraser=bluefrog.com@autox.team.net] On Behalf Of
Russ and Tammy C.
Sent: Thursday, July 03, 2008 8:53 PM
To: tigers@autox.team.net
Subject: [Tigers] 5 liter Ford racing motor
I have just discovered that the Lakewood Bell Housing will not fit the
tunnel without modification. I have also discovered that if I were to go
back to a standard 6 bolt bell housing, that the clutch arm from the 260 is
too short.
Anyone know how to get a longer clutch arm and/or make the modifications to
the tunnel? Thanks, Russ _______________________________________________
Support Team.Net http://www.team.net/donate.html
You are subscribed as rfraser@bluefrog.com
Tigers@autox.team.net http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.101 / Virus Database: 270.4.4/1531 - Release Date: 7/2/2008
7:02 PM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|