Pete
Any hardware store sells foam window insulation in 1/2 or 3/4 wide rolls
sticky on one side. Wrap it around the core and you're done. Dont
use adhesive to stick it to the bottom. How would you remove the
next time?
SS use to sell the gasket that goes under the bonnet latch. If not
make one.
Sorry no duckbill here.
Dave
In a message dated 4/21/2008 1:23:29 P.M. Central Daylight Time,
laurin212@yahoo.com writes:
quick questions (didnt find an answer on TE/AE site):
(1) when re-assembling the heater core, what kind of gasket/stripping do
folks
use to plant the core down against the base of the "box", silicone rubber for
heat resistance? can seem to find the right stripping, preferably
self-adhesive. should the stripping run around the bottom hole, and also up
the back and top of the core (like in the diagram on SS web site)?
(2) for the rubber duckbill piece - is it best to install this part from
within
the car, or from the box the heater core resides in?
(3) anyone hanging onto a spare duckbill they'd be willing to sell, mine was
cracked, hardened and shredded from the arizona heat
thks!
peter
Peter Laurinaitis
peter.laurinaitis.wg02@wharton.upenn.edu
You are subscribed as djoh797014@aol.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
**************Need a new ride? Check out the largest site for U.S. used car
listings at AOL Autos.
(http://autos.aol.com/used?NCID=aolcmp00300000002851)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|