Peter,
I searched for a #97 bulb image on Google, but found none. From your
description I assume this is a bulb with opposing side pins that both index
the bulb and with a slight twist cause the bulb to lock in place?
Recently I had to replace a VERY standard, 1157 bulb. I could not get this
new bulb to "lock in." After a closer look I found the glass part of the
bulb where it attached to the metal base, though tapered was bulged wider
than the original bulb I removed. Thus, this prevented the new bulb going
deep enough into the socket. While this bulb might still fit the majority of
sockets out there, on the car I was replacing it on, it did not.
Anyway, you might want to see if that is the problem.
Tom
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|