| To: | James Barrett <jamesbrt@mindspring.com> |
|---|---|
| Subject: | Re: Fulcrum Pins |
| From: | James Barrett <jamesbrt@mindspring.com> |
| Date: | Mon, 15 Oct 2001 20:38:58 -0400 |
Folks,
After reading John Logan's article I can say I am a little
late with the idea. Congradulations John.
> Have you considered adding some sort of bracket to the front and
>rear of the pins? Consider a steel bar roughly 14" X 1 1/2"X 3/4" welded to
>the cross member parallel to the lower fulcrum pin with a couple of 1/2"
holes
>tapped into the ends of the bar....
James Barrett Tiger II 351C and others
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Clutch pedal creak and pop, James Barrett |
|---|---|
| Next by Date: | Oil Pan, enof |
| Previous by Thread: | Re: Fulcrum Pins, James Barrett |
| Next by Thread: | Torque spec, RGGAMMA |
| Indexes: | [Date] [Thread] [Top] [All Lists] |