| To: | tigers@autox.team.net |
|---|---|
| Subject: | Caster/Camber Gauge Adapter |
| From: | James Barrett <jamesbrt@mindspring.com> |
| Date: | Mon, 25 Jan 1999 21:05:58 -0500 |
Folks,
I was looking for a good Caster/Camber Gauge on the Net. I found many
listings; however I also found that one needs an adapter to mount it to the
hub. There were many adapters, but none listed for a Tiger. Before I go out
and measure the hub, nut and spindle thread size has anyone aquired a good
gauge that fits OK? If so, I could use the brand name and part number.
I am looking for a gauge in the range of $170.
James Barrett Tiger II 351C and others
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Intake - Reply, Bob Palmer |
|---|---|
| Next by Date: | Re: Hydraulic pressures, Bob Palmer |
| Previous by Thread: | Rubber Molding/Weatherstrip Question, BlueGolfer |
| Next by Thread: | Re: Caster/Camber Gauge Adapter, Doug Mallory |
| Indexes: | [Date] [Thread] [Top] [All Lists] |