On Thu, Feb 18, 2010 at 1:36 PM, <hmortada@aol.com> wrote:
Any recommendations, on how to sand them, what to use, how to make or
get the black patern on them or just use a professional shop.
Bead blast them to clean them up. Then lay the silver paint on the
whole wheel. After it cures, mask the silver with masking tape. Cut
the tape away with an Exacto hobby knife where it overhangs. Shoot the
face with clear to seal the tape where the silver/black meet. Let that
cure. Shoot the semi-flat black and let it cure. Remove the masking
tape... You're done!
--
Kent
1960 Bugeye
1967 Sprite - following in the 73's footsteps to the boneyard...
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|