Frank Clarici wrote:
> I am giving up. Anybody got a DCOE in trade for about a 1/2 dozen
> pairs of SU-ck carbs?
> 3 different carb bodys, 4 different float lids, 4 new needles and
> seat, and 100 combinations of gross jets, old needles, NOS needles,
> new needles and lids.
> It still leaks.
> I even stuck a pressure regulator on it and have it down to 1 pound.
> It still leaks but at least it doesn't squirt over the radiator now.
> There is no reason for the leak and no cure.
> It is coming out of the overflow on all lids, early lids, later lids
> with the pipe to charcoal can tube, old lids, even a new SU in a box
> lid, they all leak.
> I have bent the float tabs to the max, no change, it's fine for 2
> minutes and then it starts to weep and finally pour out.
> Never at an idle, never with just the key on, only when I rev it up.
> At first I thought it was the tab on the carb body that locks the
> float bowl in place, it was missing or sheered off. So new body,
> correct rubber grommet for the offset, same problem.
> Even a known good carb leaks only on this 58.
> So much for my original Sprite, I have had enough of SUs, I can't
> stand the whimpy stock shifter, the steering wheel is great if you
> like steering with your knees, and a tach drive generator might have
> been OK back in 1958 but an alternator doesn't make nearly as much noise.
Sooner or later you will finally learn something about Spridgets.....
Keep trying!
Regards, Bill
|