spridgets
[Top] [All Lists]

Re: Re[2]: Bumper cars in Portland Oregon!

To: "David Riker" <davriker@digitalpath.net>, "Billy Zoom"
Subject: Re: Re[2]: Bumper cars in Portland Oregon!
From: "Guy R Day" <grday@btinternet.com>
Date: Thu, 18 Jan 2007 11:14:47 -0000
I came across this chap who used to place two 2ft x 3ft x 2in concrete 
paving slabs in the trunk of his car in winter to give additional weight and 
traction over the drive wheels.  Worked fine 'till he went down an ice 
covered fairly steep hill where studs or chains were really needed.  He slid 
and stopped in the stone embankment at the bottom of the hill.  The paving 
slabs continued forwards at impact speed, slicing through the metal behind 
the rear seat.  As they were slicing through, the metalwork bent 
sufficiently to lift the slabs so they went into and through his mother's 
lower back.  She was sat in the rear seat.  Submitted a report to the 
Coroner on that one.

Just a gentle word of warning, tie the weight down well.  50lb moving at an 
impact speed - of say 30mph can provide a lot of pain!


Guy R Day


----- Original Message ----- 
From: "David Riker" <davriker@digitalpath.net>
To: "Billy Zoom" <billyzoom@billyzoom.com>; "Bill L" <pythias@pacifier.com>; 
"Frank Clarici" <spritenut@comcast.net>
Cc: <spridgets@autox.team.net>
Sent: Thursday, January 18, 2007 6:13 AM
Subject: Re: Re[2]: Bumper cars in Portland Oregon!


> A 50lb bag of sand right behind the seats, some studded mud and snow 
> tires, and a Midget will go through about 8-10" of snow, and or ice.
> Been there done that!...
> David Riker




<Prev in Thread] Current Thread [Next in Thread>