The area at the end of the crankshaft that can be used is almost 9/10th of
an inch. Even a 3/4 inch input shaft would be OK with a thin bearing layer.
The length/depth of the input shaft can be controlled by the thickness of
that cut down tranny case.
Pa
----- Original Message -----
From: "WFO Herb" <froggi60@gmail.com>
To: "derf" <derf247@gmail.com>
Cc: "Spridgets" <spridgets@autox.team.net>
Sent: Tuesday, January 16, 2007 1:09 PM
Subject: Re: How bout a T-5 Tranny?
> I would think the input shaft to be a different diameter (much larger).
|