Re: Block flaw?

[Frank Clarici <spritenut@comcast.net>]

Joe Lansing wrote:

> When I removed the
> timing gear and chain I found a hole that passes
> completely through the block, from the smooth machined
> side behind the chain to the inside. It is not
> uniform. 
This hole is on all 1275s, very similar to the hole in the center web 
under the center main bearing carrier.
I think they used a hammer to make these holes.
It's for oil flow. Do NOT plug it up ;)
--
Frank Clarici
Toms River, NJ

Your messages not reaching the list?
Check out http://www.team.net/posting.html

===  Help keep Team.Net on the air
===     http://www.team.net/donate.html

===  unsubscribe/change address requests to majordomo@autox.team.net  or try
===  http://www.team.net/cgi-bin/majorcool
===  Other lists available at
===      http://www.team.net/mailman/listinfo
===  Archives at http://www.team.net/archive
===  http://www.team.net/the-local
===  Edit your replies!