David,
Use some non-hardening sealer (I like Form-a-gasket #2) in the slots in the
pan, then put the cork seals in so that an equal amount of the extra length
sticks up on each side. Once you bolt the pan onto the block the cork
compresses to make a good tight seal.
Glen
> to retain my amateur status, here goes:
>
> After jillions of mini engines, here I am building a standard
> motor.
>
> The end half-seals that fit the slots in the oil pan:
>
> How do they go? They don't look right to me.
>
>
>
> Thanks,
>
> David McCartney
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|