Ralph,
The EN40 Cranks have EN40 cast (not stamped) prominently on the
side of one of the throws. It will be cross drilled at the rod journals.
Non-EN40 cranks can also be cross drilled. A crank stamped 1312 is a
EN16or17. I'm not familiar with the other number. One way to test an
EN40 crank is to take a small round file and try to file a marking into
your two cranks. The 1312 will cut relatively easy. The EN40 will not.
Regards,
Tom Speed
Charlotte, NC
-----Original Message-----
From owner-spridgets-mod at autox.team.net
[mailto:owner-spridgets-mod@autox.team.net] On Behalf Of Giro, Ralph
Sent: Thursday, January 16, 2003 3:15 PM
To: spridgets@autox.team.net
Subject: Cranks ID
Can you give me any info on these 1275 cranks? They are from Spridgets
not Minis. Serial numbers on the cranks are:
SCF3117S2
G1321
How can you tell if a crank is an EN 40 ?
Any info would be appreciated.
Thanks !
Ralph Giro
Gainesville, FL
72 Midget Vintage Racer (Rusty)
67 Midget - Long Term Resto.
/// Send your messages to spridgets@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or
try /// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|