I am currently working on a 1275 cylinder head and noticed that only the intake
valves have oil seals. The catalogs show this to be correct. My question is,
should I replace the seals as they were or is there an improvement such as
installing seals to all valves that would be better? It seems that adding
seals to the exhaust would not be difficult. The engine is stock, I just can't
figure why there would be not be seals on all valves. TIA.
Dan Walters
'63 Sprite
'74 Midget
Brick NJ
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|