Bob Van Kirk wrote:
>
> List,
> Need help in changing a bugeye from positive ground
> to negative ground.
Polarize the generator by taking a stout wire and arcing it from the
FIELD (small terminal) of the generator to the HOT side of the battery
(+ in your case if you are converting to - grd)
also, be sure to switch the coil wires. If the original coil is still
there, move the white wire from SW (switch) to CB (contact breaker)
And Vise Versa.
If it is a later coil, the white wire should go to + the white/black
should go to -.
Double check the heater blower too, I had one suck air out of the
cockpit. If this happens, just switch the wires at the heater motor.
--
Frank Clarici
Toms River, NJ
http://www.exit109.com/~spritenut
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|