Hey... that my little trick (been doin' that for a while myself. Pretty
neat isn't it?!!
Gerard
At 10:02 PM -0600 4/13/02, shelden wrote:
>I've been playing with aligning the seat mounting holes in my Midget for
>about an hour now. I'm adapting MGB seats to my car. As I was trying to
>find the best way to put a clean hole in my carpet it dawned on me that I
>could install the carpet and then use a pencil type soldering iron from the
>bottom side of the floor and push it up through the hole, melting its way
>through the carpet and leaving a nice clean hole. What I now have are 4
>perfectly aligned clean holes for mounting my seat bolts in. I'm sure you
>seasoned spridgeters already figured this out but for this newbie it was
>eureka!
>
>Hope this helps someone out there.
>
>Charlie Shelden
>OKC, OK
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|