I had about twenty lines of explanation going out and then saw LM's picture!
Mine looks just like this too, but a little greasier. Picture worth thousand
words.
Geoff Branch
'74 Meejit "Yellow Peril"
'72 Innocenti 1300 Mini
----- Original Message -----
From "Larry Miller" <millerls at ado13.com>
To: "shelden" <shelden3@pldi.net>; <spridgets@autox.team.net>
Sent: Thursday, October 18, 2001 1:03 PM
Subject: Re: throttle set up
> http://ado13.com/redcar/bugeyeweber.jpg
>
> This setup is with the Cannon manifold. I used the dash end of an old choke
> cable. Drilled out the hole in the manifold tab so that the choke cable
> guide would fit through it, drilled out the hole in the choke cable guide so
> that the end of the throttle cable would go into the hole but not all the
> way through to act as a stop.
>
> If you want to put the nut on the choke cable guide (I did not) to lock it
> into the manifold, you will need to grind the backside of the manifold tab
> to make room for the nut and to expose more of the thread on the choke cable
> guide.
>
> Larry Miller
>
> ----- Original Message -----
> From: "shelden" <shelden3@pldi.net>
> To: <spridgets@autox.team.net>
> Sent: Thursday, October 18, 2001 10:34 AM
> Subject: throttle set up
|
