Toby,
Did ya get a real answer to this?? It is pretty hard to explain (well for me
any way ;-) There are a couple VERY good explanations in the Archive. Yes it
is still up, and no it has not been updated since Oct '00.
Larry
On 3/22/01 7:13 PM, "Toby Atwater" <tob.sprite.landcruiser@home.com> wrote:
> I am gonna have to do this exact same job in about a month or so without an
> adjustable cam sproket. What is the procedure, time it in a few degrees in
> advance to the nearest tooth? My machine shop camed it in stright up I
> belive and for performance, vizard recommends some advance. Any ideas on how
> many degrees to a tooth?
>
> Thanks
>
> Toby
>
>
Larry Macy
78 Midget
Keep your top down and your chin up.
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a question
and you're a fool for the rest of your life.
///
/// (If they are dupes, this trailer may also catch them.)
|