I need to be setting the timing on my Cam. That is about all that is left to
finish up the engine. However I was trying create a degree wheel and am
having a hard time finding the right software to do it. I can create a pie
chart with 360 slices but it gets too ugly when printed.
I was wondering if anyone had a pattern for a degree wheel they could send
me that I can print out and attach to a piece of aluminum. Got a friend that
can do this if I can print the pattern. I am trying to see if I can get
close enough with out spending $250 for the adjustable cam sprocket. I will
if I have to, but trying to avoid it if unnecessary.
Thanks
Larry
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Administrator/Manager
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 1015 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a
question and you're a fool for the rest of your life.
///
/// (If they are dupes, this trailer may also catch them.)
|