John,
Been flooding in parts.... Wear your rubbers!
NewNGsInfo@cs.com wrote:
> Ulix,
>
> I'm not sure what you have it bored to now, but I have a torque plate that
> correctly centers the correct offset required to get the 1380 bores placed
> right. It has been used by two different machine shops who both praised it's
> value for centering and gives you a good "as torqued" status for final honing.
>
> So, if you need to re bore (offset) for 1380, this plate will be a good
> guide. I would never sleeve a block if any other was avail.
>
> I'm off to London and will not be avail. past this afternoon (until next Tue.)
>
> Good Luck, John Carey
|