I used MM's roller TO bearing in my ribcase before I did the 5-speed
conversion.
I only put about 1500 miles on it, but it seemed to work fine for me. I was
alittle concerned about the fact that the carrier is made out of a 'plastic'
material, but I also talked to the folks at Winner's Circle, and they said they
used the same type, and they never had any problems with it.
Regards - Bryan
>Subject: release bearing(throwout bearing)
>To: spridgets@autox.team.net
>MIME-Version: 1.0
>
>I wondering if any one has tried the roller release bearing for the clutch
>from minimania? I have a 73 midget with the engine and trans out on the floor
>at this time, so now is the time. Any thoughts appreciated.
>
>on a side note my restoration project is comming along quite nice. I posted
>some notes quite some time ago on structural questions. I ended up putting a
>good front half and a good rear half together. a chore but very nice.
|