| To: | David Christman <dpc@ai.mit.edu> |
|---|---|
| Subject: | Re: wrench sizes |
| From: | HFC <froggi@cdsnet.net> |
| Date: | Wed, 09 Jun 1999 13:32:29 -0700 |
| Cc: | spridgets@autox.team.net |
| Organization: | WFO Racing |
| References: | <199906090110.VAA23431@trix.ai.mit.edu> |
| Reply-to: | HFC <froggi@cdsnet.net> |
| Sender: | owner-spridgets@autox.team.net |
...you'll need a 1 7/8" for the nuts on the rearend! WFO Herb David Christman wrote: > I am buying a new set of fractional inch wrenchs. I've been metric > all these years. My question: How useful is it to have wrenches > larger than 3/4" for spridgets? I have used sockets for everything > greater than 19mm (3/4") in the past. > > thanks. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Bugeye Fuel line / Fuel Pump, Bob Frato |
|---|---|
| Next by Date: | Re: paint for valve cover, Jeff Boatright |
| Previous by Thread: | Re: wrench sizes, Frank Clarici |
| Next by Thread: | Re: Ulix (c'est moi), VolksPEZ |
| Indexes: | [Date] [Thread] [Top] [All Lists] |