| To: | spridgets@autox.team.net |
|---|---|
| Subject: | wrench sizes |
| From: | David Christman <dpc@ai.mit.edu> |
| Date: | Tue, 8 Jun 1999 21:10:34 -0400 (EDT) |
| Reply-to: | David Christman <dpc@ai.mit.edu> |
| Sender: | owner-spridgets@autox.team.net |
I am buying a new set of fractional inch wrenchs. I've been metric all these years. My question: How useful is it to have wrenches larger than 3/4" for spridgets? I have used sockets for everything greater than 19mm (3/4") in the past. thanks. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Gasket material, wicking?, Frank Clarici |
|---|---|
| Next by Date: | Re: Ulix (c'est moi), VolksPEZ |
| Previous by Thread: | Just curious... Bugeyes vs Car Alarms, conan |
| Next by Thread: | Re: wrench sizes, Frank Clarici |
| Indexes: | [Date] [Thread] [Top] [All Lists] |