Re: LONG, Update to Fulcrum Pin, '79 Midget

[Ulix Goettsch <ulix@u.washington.edu>]

On Tue, 1 Jun 1999 Lancer7676@aol.com wrote:

> functional but worn--and required replacement.  AND they must be melted or 
> heated out of place and the new ones soldered in with the new fulcrum pin IN 
> PLACE to assure alignment.  Whew!   Any way you go about it this is still one 

David,
I would not solder the bushings with the new pin in place as the heat may
damage the pin.  Use a good old one if you have one or buy three.  :-) 

    Ulix                                       __/__,__      ___/__|__  
..............................................(_o____o_)....<_O_____O_/...
                                              '67 Sprite     '74 X1/9