| To: | David Ramsey <dwramsey@worldnet.att.net> |
|---|---|
| Subject: | Re: 5-speed clutch |
| From: | Chuck Ciaffone <chuckc@ibm.net> |
| Date: | Sun, 26 Jul 1998 08:22:25 -0400 |
| Cc: | spridgets@Autox.Team.Net |
| References: | <MAPI.Id.0016.007772616d7365793030303830303038@MAPI.to.RFC822> |
| Reply-to: | Chuck Ciaffone <chuckc@ibm.net> |
| Sender: | owner-spridgets@Autox.Team.Net |
I had a sorta similar problem with the clutch on my Riverside (gate?) kit. If you have the slave with the adjustable pushrod, back of on the pushrod to leave a little slop. (You are probably overdriving the clutch plate.) If you don't have the adjustable pushrod, try finsing another pushrod and shortening it a bit. chuck -- ===================================================== chuck ciaffone chuckc@ibm.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Bugeye wheel bearings, tzuchow |
|---|---|
| Next by Date: | Re: Pinion seal nut size?, The Tobins |
| Previous by Thread: | Re: Inferior Parts, Frank Clarici |
| Next by Thread: | Re: 5-speed clutch, Frank Clarici |
| Indexes: | [Date] [Thread] [Top] [All Lists] |