Dennis Reese wrote:
> I decided to completely redo the front suspension on my 1500. Just about
> finished but....I can't get the new calipers to fit and I'm guessing that the
> bearing seal is wrong and therefore the hub isn't seated properly and forcing
> the rotor against the outer edge of the caliper. You can probably tell I don't
> know what I'm talking about so expert input is needed here. Should the felt
> face the bearing? What would happen if I ditch the metal cup and just use the
> felt? The cup is slightly larger than the hub.
>
The felt should face towards the center of the car, it should be the part
that rubs against the upright.
mjb.
_______________________________________________
Spitfires@autox.team.net
Archive: http://www.team.net/archive
|