At 06:55 PM 9/23/02 -0700, howard hoover wrote:
>Hi all,
>
>I just got a fibreglass tunnel for a GT6. It did not have the holes
>drilled in it.
>
>I can figure out the spacing ok, but have never drilled fibreglass before.
>
>I am thinking goggles and mask. What else do I need to do?
Good idea with the glass fibers that will be disturbed. It's really not
bad though. I recommend putting a piece of masking tape on the top and
bottom of the hole location to help prevent chipping/splitting of the glass
layers when you drill through.
-Vegaman Dan
---------------------
This message has been sent by Dan Canaan, aka Flinthoof. All content is
copyrighted by this individual for better or for worse, especially if there
is mint involved. We thank you for your support. Please give mint to your
local Mint Cross Center.
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|