shop-talk
[Top] [All Lists]

Re: [Shop-talk] throttle cable end/terminal (?)

To: Shop Talk <shop-talk@autox.team.net>
Subject: Re: [Shop-talk] throttle cable end/terminal (?)
From: Tim <tputland@charter.net>
Date: Tue, 11 Jun 2013 14:30:52 -0400 (EDT)
Delivered-to: mharc@autox.team.net
Delivered-to: shop-talk@autox.team.net
User-agent: Laszlo Mail 3
Thanks to the few of you who responded. Since you all pretty much 
thought that attachment that came in the kit looked ok, I went ahead and 
used it. It provides great movement that is very smooth. Once I get a 
bigger cotter pin I should be dialed.

Thanks again!
tim


On Sun, Jun 2, 2013 at 3:50 PM, Tim wrote:

> Not sure what to call it but I would like to use a different
> end/terminal that what was included with this carb linkage kit:
>
> http://www.flickr.com/photos/82293958@N06/8928731354/
>
> Looking for suggestions to replace the little bits you can see on the
> left that has the cable stuck in it for the picture. (I do have a new
> cable that is not frayed.) I donbt like how these little bits are
> supposed to hold the cable. Also, it is all held on the rod by the
> smallest and thinnest wire cotter pin I have ever seen. The rod on the
> right is just the bare rod that will receive the replacement part that
> holds the cable shown as a reference.
>
> Whatta think?
> Thanks
> tim
_______________________________________________

Shop-talk@autox.team.net
Archive: http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>