Re: [Shop-talk] making a slot in aluminum plate

["Elton E. (Tony) Clark" <eltonclark@gmail.com>]

 *I'll vouch for the router method; I    used a carbide bit in a router
table*
*to make a carburetor adaptor and it*
*was a piece of cake.*


> Do you have a router? Use a carbide bit to mill out the slot. Use a
> straight edge to guide the router base.
>
> Eric Russell
> Mebane, NC
> http://home.mebtel.net/~**ejrussell <http://home.mebtel.net/~ejrussell>
>
> ----- Original Message -----
>
>> I need to find a way to make a nice clean slot in 3/16" aluminum
>> plate...approx 1/8" wide and 2 to 3" long.
>>
>  ______________________________**_________________
>
> Shop-talk@autox.team.net
> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Suggested annual donation  $12.96
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/**
> 
>options/shop-talk/eltonclark@**gmail.com<http://autox.team.net/mailman/options/shop-talk/eltonclark@gmail.com>
_______________________________________________

Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums