shop-talk
[Top] [All Lists]

Re: [Shop-talk] faucets, mixing valves, and regular valves

To: shop-talk@autox.team.net
Subject: Re: [Shop-talk] faucets, mixing valves, and regular valves
From: Mark Andy <marka@maracing.com>
Date: Fri, 1 Jul 2011 09:45:52 -0400 (EDT)
Howdy,

On Thu, 30 Jun 2011, Pat Horne wrote:
> A mixing valve should work for you if you don't need mass quantities of 
> water. They are usually plumbed with 1/2" line. which is fine for sever 
> gallons a minute, but not much more.
>
> If you decide to go with a DIY of 2 valves I would recommend ball valves 
> instead of gate valves. They shut off better and can pass more water than the 
> run of the mill (Lowes) gate valves. They are probably cheaper also.

I've been having trouble finding a mixing valve (other than a regular 
faucet)... Got a link?

1/4 turn ball valves would be fine, but I was worried that I'd be using 
them partially open a lot.  The other question with the two valve approach 
is that I'm not sure what happens if I have both valves partially open and 
the hose handle off so that there's no flow out the end.  Will I get 
hot/cold water mixing in the lines?  And is that a problem?

Mark
_______________________________________________

Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>